[Verkocht] Lumenier LUX F3 flightcontroller

Te koop: Lumenier LUX F3 flightcontroller (2x).

Wegens overstap naar KISS FC bied ik mijn Lumenier LUX flightcontrollers te koop aan.
Beide hebben weinig vluchten gehad en werken als nieuw. De pinheaders heb ik er op gesoldeerd.
Naar mijn mening de FC met beste en fijnste pinlayout voor Betaflight/Cleanflight.

Prijs per stuk: 20 euro incl. verzendkosten.

Informatie van Lumenier website:

Features:

  • USB Conflict resolution - Hardware inversion, SBUS or telemetry can be used on any of the 3 available hardware serial ports. USB will not interfere with peripherals.
  • Betaflight ready - including High Speed SPI 8khz Gyro sync (MPU interrupt connected to F3, allowing the F3 to know immediately when fresh data is available.).
  • Dedicated Boot button for easy firmware flashing.
  • Reinforced solder pads for trouble-free direct soldering.
  • Extremely low profile design.
  • Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.
  • Integrated FRSky RSSI Filter (RC filter).
  • Input voltage 6v to 24v. Power the board directly from flight pack up to 6S (on ‘BAT’ pad only!).
  • VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
  • Filtered voltage output - output 5v 1A (and 3.3v where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.

Specifications:

  • STM32F303 32-bit processor
  • MPU6500 Gyro/Accelerometer
  • High quality, gold plated PCB
  • Highest quality components, individually sourced to meet Lumenier standards
  • Micro USB connector for programming
  • Dimensions: 36x36x6mm (includes USB in height)
  • Mounting Holes: 30.5mm square to center of holes
  • Weight: 6g

Ik heb wel interesse!

Verzonden vanaf mijn iPhone met Tapatalk

Beiden zijn verkocht, kan slotje op.